Farmall & IHC Tractors Discussion Board |
Re: ? for the tractor vet
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on September 26, 2005 at 09:46:18 from (4.124.73.222):
In Reply to: ? for the tractor vet posted by McDiesel on September 25, 2005 at 22:11:37:
If it is and I H plow of the 540-660 -700-720 seires then yes as all I H plows were built on a basic 3 bottom setup , like i said remove the tail wheel and gauge wheel by unbolting them from the rear bottom and amssure how much plow beam there is from the botttom hole to the end of the beam and them you know just how far back from the third bottom to make your cut and rebolt the tail wheel and gauge wheel . If you take a real close look at the main beam you will see the extra holes from the third bottom on back. then the last thing to do is shorten up the coupling pole. Some times ya have to change the hitch pins from 2's or 3's to cat. 1 and it is best to bite the bullet and by them from Case IH as the ones ya get aftermarket are not strong enough.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|