Farmall & IHC Tractors Discussion Board |
Re: Farmall-A 6V 4-Position Switchbox Coil
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pharmall on June 16, 2005 at 07:49:07 from (68.9.106.167):
In Reply to: Re: Farmall-A 6V 4-Position Switchbox Coil posted by Kendog on June 16, 2005 at 06:12:39:
My new milliohmmeter only has a 1 ohm resolution, so the resistance could be anywhere between 100 milliohms and 2 ohms. At those levels it makes a difference how hard you press on the connections. If your resistor is already broken, it wouldn't hurt to try and braze it. The braze alloy will have a lower resistance than the wire, so it shouldn't develop a hot spot or increase the resistance of the system. Biggest problem I've run into in restoring my '48C is corroded and rusty connections. They can add a lot of resistance in the circuit and really upset the intent of the original design. Good luck. Jeff There is a pretty good article on three brush generators at: http://www.ytmag.com/articles/artint4.htm I'll try to attach the link on this message.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|