Farmall & IHC Tractors Discussion Board |
Re: B rocker arm bushing measurements
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BobOH on June 14, 2005 at 16:36:31 from (66.155.160.46):
In Reply to: Re: B rocker arm bushings/blueprints specs? posted by Pharmall on June 14, 2005 at 16:19:02:
I bought one bushing. OD is .875 and ID is .743 and overall length is 1 inch. The shaft on my B measured to be .747 and the book said to ream it out to get a .004 clearance. I bought one for the rocker on my B that was REAL bad (had about 1/4 of slop) but all of the others don't look real good and thought maybe this would be the time to do them all. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|