Farmall & IHC Tractors Discussion Board |
Re: Reservoir Lid Utes
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Unreserved dick on May 06, 2005 at 18:53:46 from (4.228.129.186):
In Reply to: Reservoir Lid Utes posted by PAULIH300 on May 06, 2005 at 17:56:03:
It's an outstandingly poor design by IH. My screen was collapsed also, like Harold's,and that's probably the typical case. The "T-screen" hangs down two or three inches below the gasket surface, and is thus prone to mechanical damage when you're taking it apart. Sounds as though you're getting ready to do some heavy hydraulic work, including going in after this rascal. It so, make sure you lift the cover straight up, and have a plan/place to set it down, or you'll probably end up replacing the screen whether it really needs it or not - was about $70 from CaseIH a couple of years back. It's also very helpful to pull all the valves off the side to reduce the weight and put the center of gravity in the middle when you're pulling the cover; thing's awfully heavy and awkward in any case. It's a good job to get some good help with.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|