Farmall & IHC Tractors Discussion Board |
Re: Finally painting my H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul in Mich on April 14, 2005 at 04:04:21 from (152.163.101.13):
In Reply to: Finally painting my H posted by Mike3501 on April 13, 2005 at 17:00:23:
Mike, I"ve restored 2 tractors, and havn"t used a sand blaster on either, and while I suppose a sand blaster would be ok for some parts taken away from the tractor, I would never sand blast anything near the tractor or anything that if invaded by sand would cause damage. That just about leaves wheel weights and rear wheel castings. I do however use an air needle scaler for all the castings which works great along with wire brushes, pocket knives, sand paper, wire wheels, oven cleaner, carb and brake cleaners, and anything else that ends up, while being labor intensive, gets the job done. As Cowman says, preparing to paint takes far much longer than painting itself.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|