Farmall & IHC Tractors Discussion Board |
Re: CNKS ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on March 15, 2005 at 07:36:21 from (204.249.178.138):
In Reply to: CNKS ? posted by TDK on March 14, 2005 at 19:20:32:
The link is in more or less alphabetical order, scroll about 3/4 of the way down until you see "MP 170 Epoxy Primer" it will tell you all you need to know. I don't know why you can't scuff and paint, I haven't tried it. I always try to follow the instructions as PPG knows far more than I do. Use PPG's MP 181 surfacer on top of the 170, not the "red oxide" stuff. IF and only if you have a supplied air system you can use MP182, it requires hardener. I believe both 181 and 182 are gray. Some people don't like that because chips and scratches show more. I like gray, because you can see the places you missed and tough them up (within the allowed time). 170 is gray also. Print out all the spec sheets for the products you are using, I have mine taped to the wall where I mix the paint.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|