Farmall & IHC Tractors Discussion Board |
Re: Farmall 706 310d sleeves
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by El Toro on March 03, 2005 at 12:57:51 from (205.188.117.13):
In Reply to: Re: Farmall 706 310d sleeves posted by Trent R. Young on March 02, 2005 at 17:00:12:
Glad you got the sleeves removed. I would set those valves somewhat loose until you get the engine running. .012" on the intake and .014" on the exhaust. This will probably change when the engine gets up to operating temperature. You should clean the block area good where the old sleeves were installed. When you're ready to install the new sleeves you keep them in your freezer for a few days and they should fit very easily into the block without having to drive them in. Once you have them installed and they have a few hours to thaw, I would dry them with clean rags or paper towels and coat the sleeves with engine oil. If you're thinking about reusing the old sleeves I would have them checked for wear at a good machine shop. New sleeve and piston kit would be the way to go. The crankshaft should also be measured for wear or any egg-shaping. This and tight cam bearings determine your engine having good oil pressure. Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|