Farmall & IHC Tractors Discussion Board |
Re: Farmall B transmission
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by captaink on January 23, 2005 at 20:05:24 from (64.33.250.37):
In Reply to: Farmall B transmission posted by Matt Matula on January 23, 2005 at 19:06:45:
I’ll state the obvious first, that being that the reason the gears are grinding is that the gears are still moving. Why they are moving is the question. Did you check to make sure that the clutch fingers are set correctly, and the clutch is adjusted properly. Does the clutch disengage or is it “dragging” a little bit. Any drag on the clutch will keep the top shaft in the transmission spinning, causing the gears to grind. If the clutch is dragging any at all that is where your problem is. The slinger gear that you mention is needed only if the tractor is stationary and the PTO is in use. That slinger gear runs in the transmission oil and thus would add resistance to help stop the shaft when the clutch is depressed. That means that it will take longer for the transmission top shaft to stop rotating than it would if the gear was in place. My B takes some time for the gears to stop which can be quite annoying.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|