Farmall & IHC Tractors Discussion Board |
Re: clutch relese fork return spring pin on 45 H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Theman on December 16, 2004 at 09:37:31 from (65.248.77.5):
In Reply to: clutch relese fork return spring pin on 45 H posted by mike66 on December 15, 2004 at 07:55:31:
If you tinnk this pin will cause trouble later, now is the time to fix it. You should be able to remove it with a drift and hammer. If you can't find a replacement, weld the hole up and re-drill after letting it air cool. The liftall on my '47 H had a rubber seal in the casting for the control shaft. You have to take the pump out of the housing and loosen the clamp screw on the actuator bellcrank to remove the shaft. The counterbore for the seal will be evident when you remove the shaft. If CIH doesn't have the part, a bearing retailer can sell you a seal that will press into the housing. You have to give them the counterbore ID, shaft OD, and the depth of the counterbore.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|