Farmall & IHC Tractors Discussion Board |
Re: Farmall 100 Engine Rebuild Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hobo,NC on November 10, 2004 at 06:16:55 from (151.213.82.42):
In Reply to: Re: Farmall 100 Engine Rebuild Questions posted by ZANE on November 10, 2004 at 05:29:04:
Thanks Zane, I do plan on using the better shaft but still need the STD spec. Sleeves a piece of cake good Deal. I suspect it has a Supper kit in it will check all this out when I get the sleeves removed and can compare again the 140 engine. the piston for the 140 flat top is 3.125 and the 100 is 3.250. the flattop piston has a continuous skirt, the 100 piston has skirts that or on the sides and no shirt around the risk pin. You can see were the piston has worn around the risk pin, rubbed the sleeve, this may be the nature of the beast with a over bore kit. There is no unusual were in the sleeve in the area of the risk pin. Good thing I went with the rebuild the oil rings are shot, needs a pressure plate and ring gear best I remember is the clutch was weak. The man I got this tractor from said it had more power than a 140 so guess he was rite. The rods do have the same part # on'em
Follow Ups:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|