Farmall & IHC Tractors Discussion Board |
Re: Lubricating sleeve seals for installation
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by El Toro on October 10, 2004 at 04:47:57 from (205.188.117.22):
In Reply to: Re: Lubricating sleeve seals for installation posted by BillWV on October 09, 2004 at 19:01:54:
Hi Bill, Removing the dirt, mud, rust and scale is the hardest job to do. I always had the engine blocks degreased at a nearby machine shop. They installed new freeze plugs and cam bearings too. I took a few into where I worked and steamed cleaned them. This machine shop has been here for 75 years and does good work. All their machinists are ASE certified, most are master certified Once you get that grease and dirt off the engine is nice and clean for assembly. Very easy to repaint too. I never found any of that radiator Stop-Leak worth the effort. It usually does what you found, stop up the radiator. Another problem with radiators is most people do not change their antifreeze. Every other year I think it should be drained and flushed and install new antifreeze solution. It loses its rust inhibitor and then starts plugging up the tubes. There is some antifreeze on the market that is good for 5 years, I've never used it. I always make a 50/50 solution. It protects down to -30 degrees and it very seldom goes below 0 degrees here in eastern MD. Ten years ago it went down to -15. Good Luck, Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|