Farmall & IHC Tractors Discussion Board |
Farmall C Governor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jay (ND) on September 05, 2004 at 14:48:53 from (66.231.127.187):
I have a couple of questions of the governor on my C. I went to adjust the idle, and she ran wide open after that. After removing the governor, I see that the rock shaft, that runs the thrust bearing has a lot of end play, in and out. In the bottom of the governor case, there is a pin, and it is supposed to keep it aligned, I would guess. I *think* that while I was adjusting the yolk on the outside, that I must have turned the rockshaft and slid it out, thus making it not aligned. Is it normal for there to be this end play? Is that pin the only thing keeping it centered, or should there be bushings on the end of some sort? Also, after doing some research, I decided to examine the spring in the bottom - broke it. No problem. It was rusty as . But is the thrust bearing supposed to be a 3 piece bearing? I have 2 outer roller races, and the roller bearings themselves in their own keeper. They seem good, and I *think* it's supposed to be 3 pieces, but wanted to make sure being I'm ordering the spring anyways.Thanks in advance. Jay
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|