Farmall & IHC Tractors Discussion Board |
Re: Motor for 560
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K.B.-826 on September 03, 2004 at 18:11:54 from (209.163.30.24):
In Reply to: Motor for 560 posted by Harley1983 on September 02, 2004 at 21:44:27:
Basically any C-221, C-263, C-291, or C-301 out of a tractor or combine will work. They're all the same block. You'll might need a 60 series front cover and rear plate, but then again, your diesel also uses the same block design as the the gassers. I'd go for a C-291 out of a late 706, 756, 666, 766, or 686. The six-cylinder gas combine engines were not sleeved no matter if they were a C-221, C-263, C-291, or a C-301, so if anything bad happens, you buy a new block. The C-301 was never sleeved, and the C-221 and C-263 in 460, 560, 660, 606, 706, and 656 had loose fitting sleeves that could give trouble once in a while. The The C-291 took care of that problem with press-fit sleeves.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|