Farmall & IHC Tractors Discussion Board |
Re: Hydraulic trailer plow
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john *.?-!.* cub owner on August 13, 2004 at 06:43:05 from (208.54.220.24):
In Reply to: Hydraulic trailer plow posted by TC on August 12, 2004 at 07:20:55:
All these people that say an H won't pull two 14 inch plows need to find a mechanic. I was raised on H tractors in the Missouri hills. We had 2 Hs. One was originaly a distilate burner that had the high compression sleeves and pistons installed. It was equipped with fluid in the tires and 3 sets of weights. We used it to pull an IH plow with two 16 inch bottoms in red clay and rock. It had to work hard, but did a good job plowing about 7 to 8 inches deep. the other H had was a gas burner with standard sleeves and pistons and 2 sets of wheel weights only. It pulled a Case plow with two 14 inch plows. Most of our plowing was done in second, but it got done.
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|