Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: farm hand loader
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by michael Kaup on June 15, 2004 at 07:54:40 from (216.126.128.53):
In Reply to: Re: Re: Re: farm hand loader posted by Allan in NE on June 10, 2004 at 19:47:37:
Have accounting office and small farm. This is first chance I had to get back here. Mine must be older than 1960. It has a large shaft on either side that attaches to the rear axles with a shaft on either side at the axle that goes up to about shoulder high (sitting in seat. The two upright shafts attach to a lonnnng hydralic cylinder that extends from that high point down to about 2 foot in front of the tractor where they are attached to the working attachment section of the lift. The outer cylinders are about 3-4 inches in circumference and have rather large collars where the shaft (about 2-3 inches in circumference) goes into the cylinder and the gasket I am looking for is where the cylinder makes a working seal around the shaft. My old parts man died and like a dummy I forgot to keep the numbers of the old work around gaskets he found for me.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|