Farmall & IHC Tractors Discussion Board |
Re: C-153 in a 504
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on May 25, 2004 at 12:41:31 from (4.138.245.38):
In Reply to: C-153 in a 504 posted by Steve from NC on May 24, 2004 at 19:48:33:
Seeing as how nobody has responded, I will give it a shot. The below info is not guaranteed to be accurate. I wasn't aware that the C-153 had two different bolt patterns but it makes sense. That basic motor began life in 1939 as a A engine. It was put in Bs and Cs and later "Super Sized". When it was adapted for use in the 340 and coupled to a TA center section, the bolt pattern had to be changed. The 504 is an upgraded 340. I would assume that any motor that would bolt up to a 340, 460, 504, 606, and 656 as well as other similar tractors would fit. This includes six cylinder motors. There is plently of space in a 504. I wouldn't be surprised if H, SH, 300, and 350 motors also would bolt in. May have to change out flywheels and cluthces. Talk to Mike at Steel Wheel Ranch. I am sure that he can solve your problems.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|