Farmall & IHC Tractors Discussion Board |
Re: smta cam gear any torque requirements on nut?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on April 28, 2004 at 18:18:02 from (66.67.15.60):
In Reply to: smta cam gear any torque requirements on nut? posted by Kevin on April 28, 2004 at 15:45:57:
Kevin - I was never able to find a torque spec for the cam nut. Also because it's not a standard nut (thin pattern, fine thread), a standard threaded fastner torque table will specify more torque than the threads are good for. Anyway when I did my SM I torqued it to about 70 ft-lb. (It must be OK because it's been working fine for several years now.) Make sure the nut keeper is in good shape, it's tang is fully engaged into the keyway and the ears over at least 2 nut flats. I wouldn't worry about a few chipped gear teeth. When the nut unscrewed off mine it fell into the gears and took pieces out of several teeth on every one but the governor gear. But it still runs fine.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|