Farmall & IHC Tractors Discussion Board |
Re: Re: Re: will this work from M to H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by zak on April 07, 2004 at 07:48:05 from (128.175.85.99):
In Reply to: Re: Re: will this work from M to H posted by chad on April 07, 2004 at 06:47:58:
Chad, I've done this swap on my 300 (using a 400 WFE). The bolt holes are spaced 4 1/2" on center, square. Additionally, they are 3/4" holes for the M, while the H, 300, 350 uses 5/8" bolts. The frame rails are 18" across on the H, 300, 350 (If I recall correctly) and 20" on the larger series. You'll have to make a new rear bracket which is less difficult than it sounds if you have some plate stock lying around. The front pedestal mount can either be notched to accomodate the smaller bolt pattern, or you can cut the whole plate off your WFE and just weld a new one on (Which is what I did). The plate is easy enough to make. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|