Farmall & IHC Tractors Discussion Board |
Re: '48 Cub Final Drives
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by lee on March 28, 2004 at 07:52:08 from (24.24.92.235):
In Reply to: '48 Cub Final Drives posted by Bill V in Md on March 28, 2004 at 05:15:38:
Poor mans way, there should be clearance in the back to allow you to just tap that out with an appropriate punch working side to side. Clean up outer area of bore best you can to avoid jamming up. Take it to a bearing supply house and they'll likely have same or equivalent bearing. Naturally get both inner and outer. Difficulty getting the race back in depends on press fit. Clean everything real good, no burrs allowed. Lube generously with gear oil. Get it started squarely. Use a hard wood block over top. There is not much meat to work with once it gets flush. You might install the shaft and use the bolt to draw that together on final assembly. Tighten and strike bolt with large hard face hammer. You might also use the old inner bearing as a driving tool but be careful not to damage new race. If you use a punch on that thin outer ing on assembly you can damage or chip, wear safety glasses. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|