Farmall & IHC Tractors Discussion Board |
Aftermarket Farmall emblem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SGT K on March 11, 2004 at 08:06:15 from (216.125.213.243):
I recently finished my H and I ran into a simple problem I wanted to pass along. I purchased a new Farmall emblem for the front grill. I took for granted it would screw right on. After I finished painting and applying the decals I discovered that when I screwed the emblem on it stuck out about half an inch, and the inside was not cut correctly to match the rib in the grill. It wasn't that hard to modify the emblem and drill new holes, but I sure wish I would have done it before I had all of that fresh paint sprayed on! (yes,,,,,,,,I scratched it) If you buy a new emblem, fit it before you paint. Learning the hard way. Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|