Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: '40 model Farmall H head rebui
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by riverbend on March 01, 2004 at 16:46:36 from (208.160.33.206):
In Reply to: Re: Re: Re: Re: '40 model Farmall H head rebuild posted by bill on March 01, 2004 at 12:00:26:
You can do either, both, or nothing. Don't you love these clear cut answers ? If you have the head off, put the plugs in and pour a little gas into the combustion chambers. If none leaks into the ports after a few minutes, you might not need valve work. Doing a valve job without the rings might cause it to blow by the rings a little more, but won't really hurt anything. Oil is cheap. If it uses too much oil or smokes too much, put rings in it. I don't know if the head gasket is reusable. As long as you are not laying in the mud to do it, and if there are no ridges at the tops of the sleeves, it is easy to put on another set of rings. These tractors were made to be easy to work on. Mostly, it is remove the oil pan, unbolt the rods, and install new rings. The pistons will push right out. Be sure to keep the caps and rods together as sets (read the manual). If your oil pressure was good before, I would check the bearings with plastigage, but would not necessarily replace them.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|