Farmall & IHC Tractors Discussion Board |
Re: belly mount weight bracket
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ny bill o on February 15, 2004 at 13:07:37 from (66.24.251.60):
In Reply to: belly mount weight bracket posted by Tye on February 14, 2004 at 17:06:11:
i built one for my 560 out of 3x3x1/4" angle iron. i cut 2 pieces about a foot and 1/2 long for vertical pieces, blew hole in top with torch for 3/4" bolts into 560 frame. i used more of the same angle, just a couple inches narrower than the inside tire width, and welded the 3 pieces together. added a plate on each end of horizontal piece so weights can't slide off and hit tire. i've seen some that had an angle brace back to the tractor but mine doesn't have one. i tightened the bolts tight and it doesn't move. not fancy but it works. my digital camera is on the blink so i can't give you a picture.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|