Farmall & IHC Tractors Discussion Board |
Re: Re: Super C oil problems Please Help?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on February 12, 2004 at 05:13:05 from (208.59.157.130):
In Reply to: Re: Super C oil problems Please Help? posted by Farmall-Nut on February 11, 2004 at 17:09:54:
Both posts are good advise. You didn't say if this was a new/sudden problem, after a rebuild, or just trouble shouting an unknown. If it helps diagnose further, the oil reaches the top of the motor through the center main bearing/center camshaft bearing galley. There are three small hex plugs in the side of the block (on the oil filter side) that go into these gallies, verify that path behind the center plug is open. If your overall oil pressure is very high, I would suspect a plugged oil path(which I've seen once after a rebuild with a salvage yard block that had dirt it it that hot tanking didn't clean out), but if very low, I would suspect worn out bearings and maybe a warped cap on the oil pump. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|