Farmall & IHC Tractors Discussion Board |
Re: Super A Oil Pressure; Oil Pump
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Daniel on February 09, 2004 at 08:33:28 from (66.226.33.19):
In Reply to: Super A Oil Pressure; Oil Pump posted by PGNS on February 09, 2004 at 06:13:18:
Two things that come to mind are: 1)Excessive bearing clearance, in other words, it is time for new main and/or rod bearings or an engine overhaul. 2) Warped oil pump cover. These covers will warp over time and prevent the pump from building pressure when the oil gets hot. This would be my first check. Drop the oil pan and remove the oil pump, I think you'll see how once the pan is off. Disassemble and clean thoroughly, especially the oil pickup screen, if it is clogged you can have low oil pressure, too. Lay the cover on a piece of glass and use a feeler gauge around the edge to find the excess clearance. You can try putting some sandpaper on the glass and trying to flatten the cover by sanding but more than likely you will need a new one from IH. They are around $70.00. In any case you will need a new gasket for the cover. They are paper thin so don't try to substitute as they control the gear clearance.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|