Farmall & IHC Tractors Discussion Board |
Re: How to remove 484 exhaust manifold? (picture)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on January 22, 2004 at 16:30:51 from (24.157.143.220):
In Reply to: How to remove 484 exhaust manifold? (picture) posted by clanger on January 22, 2004 at 10:12:14:
Hi, yes that is the hot water exit. I believe you can leave both exhaust and water manifolds on. I can't remember, is the water pump attached to the head or the block ? Will the water pump stay with the head and you don't have to disconnect that rad type hose from the water manifold ? The other way is to loosen the head off and then slide it towards battery box to remove that rad hose. Just out of interest, how many hours on your 484 and what problems is it having that you require replacing sleeves/pistons ? My brother has a 454D with same engine with well over 10,000 hrs and no problems other than a couple of water pumps and cup seals on input shaft to injector pump. Good Luck, let us know how your work progresses. JB
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|