Farmall & IHC Tractors Discussion Board |
Re: changing narrow to wide front ends?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on December 02, 2003 at 12:35:37 from (68.30.89.234):
In Reply to: changing narrow to wide front ends? posted by Jim on December 02, 2003 at 09:48:27:
I just did one on my 400 and its just like what you can invision its like. Well that is untill you start it. It looks like block up tractor- Remove these 4 bolts- remove lower bolster- Bolt steering linkage to pivot shaft- bolt WF to frame. WaLa your done. HAHAHA yea right. All the bolster bolts are going to be a bear to get loose. One will spin and you have to figure out how to get a wrench on the top of it. The holes in the frame are full of hard dried mud maybe from mud dabber homes.You need to get them cleaned out. A small wire brush on a drill works good for this. You then need to hold the WF up to the frame and hook the linkage up then the WF to frame. A cherry Picker works good. Of course the holes dont exactly line up. Some soring of the holes may be in order. All in all not hard just might have to solve a few issues when doing.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|