Farmall & IHC Tractors Discussion Board |
Re: Removing front pulley, Farmall A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP(MI) on November 25, 2003 at 16:45:36 from (216.46.194.142):
In Reply to: Removing front pulley, Farmall A posted by Mark on November 23, 2003 at 14:44:46:
Hope this isn't too late! Had the same problem on my Farmall 200. Finally resorted to drilling two holes in the pulley inside the shoulder of the V, and outside the shoulder (back side) of the hub. Then a deep socket placed on the end of the crankshaft, a steel plate with holes appropriately placed to match the two I just drilled in the pulley. Put a couple bolts through the plate and pulley, and nuts on the back of pulley. Had to grind the flats on one side of the nuts to fit. Anyway, that made a custom puller that worked superbly. Used a air impact wrench - couple bumps on each bolt alternately until it walked the pulley off. Worked fine - I'm saving that setup! (Think the bolts were 5/16")
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|