Farmall & IHC Tractors Discussion Board |
Re: H-4 magneto
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Glen in TX on November 15, 2003 at 21:14:05 from (208.246.9.70):
In Reply to: H-4 magneto posted by matt Sheaffer on November 15, 2003 at 11:49:47:
You tuned it I presume with new clean, correctly set points and condenser. If you took the gears out of the gear case and didn't align the marks correctly it won't be in time and work correctly. The R mark on the dist. gear lines up with beveled tooth on small metal gear for a CW drive mag and L mark for a CCW mag. Could have a bad coil or bad wire from points to condenser. Replace wire or cover with heat shrink tubing. Check to make sure terminal under points cover isn't touching ground. Check for the brush in cap to be there and clean contacts in cap and on rotor or replace. Take off kill terminal wire to be sure that wire or switch isn't the problem. Try these simple things first. I can help with a look at it or other tests if needed. good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|