Farmall & IHC Tractors Discussion Board |
M still running rough
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ty on November 06, 2003 at 19:32:54 from (69.21.122.110):
I replaced some parts in the dist. The bushing was good but the 2 thrust washers were replaced that took the back and forth play out and is just right. Also I replaced the 2 gov springs and the weight guard because i had badly worn areas from the back and forth play of the shaft. I set the timing by putting it in the notch and then turning the dist till the spark come from the secondary cable. I played around with the carb and timing and when I screwed all the mixture screws in it purred like a kitten. Hit the throttle and it misses. Then mess around get it to sound good at fast idle idle it down then it is awfully poppy. Could it be a carb prob? All passages clear new gasket and float. Good fuel flow. Where the power comes in from the ign switch while it is running I put the digital volt meter on and it's going all over. And every time it would have a occasional loud pop it would jump to 16-19 volts. What is the dwell suppose to be on these? Plugs are burning good nice blue spark. Any body got any ideas! 12v(-) elec. ign.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|