Farmall & IHC Tractors Discussion Board |
Re: Re: Re: h hydralic question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 26Red on October 28, 2003 at 10:51:15 from (170.92.1.104):
In Reply to: Re: Re: h hydralic question posted by Greg on October 28, 2003 at 10:38:03:
You can switch your setup to a two way hydraulics by adding 3 position hydrualic control valve. Just plumb the inlet(pressure)of the valve to the output port of the liftall pump. Then run the return line into the drain plug of the lift-all pump(located underneath the tractor). Tricky part is mounting your control valve in a handy spot. Obviously to operate the system, you will have leave the lift-all pump on all the time. Or just turn it on when you need to lower or lift the disk.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|