Farmall & IHC Tractors Discussion Board |
Re: '52 Super A steering box gears
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Al on September 08, 2003 at 06:28:54 from (205.244.113.10):
In Reply to: '52 Super A steering box gears posted by Gav-n-Tn on September 07, 2003 at 19:49:24:
Probably what is happening is most of your lost motion is from wear of the woodruff keys on the sector shaft. Check your gear teeth as mentioned, Replace the bearings and bushings, and find a good machine shop to cut new keyways on the gear and shaft. You can get a new gear and shaft from caseIH but they are super EXPENSIVE!!! and if you have the old square-end shaft, you gotta find a center steering pitman arm too. Oh, and when you're done, pump it full of grease, not 90 wt gear oil. I got brand new bushings, shaft, and seals and it'll still leak a little oil!! Al
Follow Ups:
Home
| Forums
Today's Featured Article -
A Towny Goes Plowing - by Anthony West (UK). I live in an area renowned for its rural beauty. Small fields with hedgerows and trees are common place, as are small hamlets with village greens and the odd duck pond complete with swans. The center of any village once the shop is closed is the old tavern. Rustic places with cheerful names like "The Griffin" "Red Lion" or "The Plough and Harrow" are found dotted around the country lanes all over the place. The warm glow of yellowish light can be seen for quite some distance at dusk, and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|