Farmall & IHC Tractors Discussion Board |
Re: Re: M lift-all oil check dipstick
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ok here it is on September 03, 2003 at 10:42:54 from (65.172.143.39):
In Reply to: Re: M lift-all oil check dipstick posted by Nebraska Cowman on September 03, 2003 at 04:40:19:
I measured the dipstick. It is 10 inches long. Down from the top 7 inches is a mark that says "G. C. Full" I think this is to check the belt pulley gear case. Then 5 inches down from the top it is marked " HYDR. Full". Just use a piece of 5/23 welding rod (knock off the flux) to make one. Flatten the top end and run it through a washer with 5/32 hole. the flat spot will keep it from falling through the washer and the washer will keep it from falling down the pipe. That's how the factory ones are made.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|