Farmall & IHC Tractors Discussion Board |
Re: How do you get rust out of the carb
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jal-SD on August 07, 2003 at 07:24:42 from (12.17.66.110):
In Reply to: How do you get rust out of the carb posted by Frank on August 06, 2003 at 16:16:33:
Frank, go over to the Case Board archives, about page 5 or so under the "author" section & look for "Electrolysis - Have you tried it" written by Baggsy-Wy. He's got a link to the Arm & Hammer page that tells you how to set up an electrolysis process that will remove rust. (There are several artilcles there that discuss this, most by Baggsy. Look at them, too.) I was a "skeptic" so I had to try it. YOU WON'T BELIEVE HOW WELL IT WORKS! I cleaned up a carb that was a solid mass of rust using this method. I also cleaned up an 8" Cresent wrench that was so rusty you couldn't read the letters on the handle, it works great now! (My $0.02 worth. jal-SD)
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|