Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Broken bolt head.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scott m on July 23, 2003 at 18:33:21 from (24.154.98.227):
In Reply to: Re: Re: Re: Re: Re: Broken bolt head. posted by Jimmy King on July 23, 2003 at 13:15:31:
I too had the broken bolt in the H problem. I drilled the bolt and used an easy out. I think I bought the easy break version, it broke off in the bolt. Now I had a big problem. After some phone calls, I used a gouging rod in my welder and poked a hole thru the bolt, you must go all the way thru the bolt. The next thing is to heat the bolt cherry red with your torch, and spray the bolt with wd-40 or anything similar. Have the garden hose ready. If you do this 2 or 3 times the bolt will shrink more than you would think, then the easy out will work, usually turning it out by hand. Just remember the garden hose.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|