Farmall & IHC Tractors Discussion Board |
300U Steering Shaft Seals -- Need Help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kilian on March 19, 2003 at 18:20:16 from (207.230.193.42):
Last summer I replaced the steering shaft seals on my 300 Utility (it has power steering). Unfortunately, the shafts still leak, even with new seals. When I removed the old seals, I noticed that the shafts had worn some, and built up the shafts with JB Weld. I haven't used the tractor a whole lot since then, in case the new seals need to "seat" on the shafts, but I was hoping for more success. The seals are $6 a piece, so I don't want to try again with the same results. Should the next attempt be to use a "speedy sleeve" to go over the steering shafts? If so, any ideas as to correct size? I think the shaft bushings have some wear, caused by a previous owner not replacing bad steering knuckles and allowing too much slop in the steering box. Could the overly worn bushings be letting too much lube past, so much that the seals can't handle it? Thanks for the help.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|