Farmall & IHC Tractors Discussion Board |
Diameter of coolant holes in 560D block into head
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RO on February 22, 2003 at 20:59:46 from (24.124.48.58):
Are the coolant holes in the top of the block on a 560D roughly 3/8 inches in diameter or are they as large as 5/8 inches. I took my head off and afterwards took some photos of the block. I did this because I live a ways from the tractor and I enjoy looking things over when I get home. Looking at the photos, I thought I had about an eighth inch of rust buildup in each coolant hole. Today, I had just a few minutes and decided to check how hard the rust would be to remove. It appears that what I'd thought was a considerable build up, might be just the amount built up on top of the block where the head gasket circles are cut out for the coolant to pass through. Indeed, the actual coolant hole appears to be only about 3/8ths diameter. I couldn't spend any time to further check this today and thought someone experienced might be able to answer the question.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|