Farmall & IHC Tractors Discussion Board |
H Jumped Time?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hal Davis on November 19, 2002 at 04:33:58 from (12.21.137.126):
Has anyone ever heard of an H jumping time? I would think that would be more likely with an engine with a timing chain rather than one with gears. Mine was running fine, then began to be hard to start. Now it won't start at all. I'm getting good fire from the coil, but it's not getting to the plugs. If I use the electric starter there is no fire to the plugs the whole time it is spinning. When you let off the starter, the plug wire might fire once or twice as the engine coasts down. When using the hand crank, the plug wire might fire or it might not. I wonder if it is trying to fire when the rotor button is not lined up with the spark plug terminal in the distributor cap. The rotor button does not have a good tight fit on the shaft. There is some play in it. Could this be my only problem? Also, how do you remove the plastic cover that is under the rotor button, but over the points and condenser? I don't want to break anything. Thanks, Hal Davis
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|