Farmall & IHC Tractors Discussion Board |
Farmall H thermostat
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on November 14, 2002 at 18:22:59 from (192.233.162.129):
I decided to replace the origional thermostat and the hoses in my H . I took (Chiseled ) it out. The new one is different, I want to make sure I put it in correctly. I think The pointed end goes down, the pipe part goes up into the thermostat housing. I put the thermostat housing in the parts washer I noticed that where I think the pipe goes (center of housing) doesn't drain, is it plugged? I also noticed that I have a lot of scales inside the cooling system but I don't want to do much about them because I may cause a problem. On the gaskets should I put a little RTV on them? Last I was wondering if I can use Cat antifreeze with coolant conditioner in it or should I use a regular one like Prestone that was in it? Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|