Farmall & IHC Tractors Discussion Board |
Super C Flywheel Ring Gear
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Peabody on October 29, 2002 at 12:28:52 from (66.191.152.251):
I have been mulling over this and trying to avoid replacing my flywheel ring gear, but the starter drive made a grinding noise again yesterday, even after I had replaced it the week before last. Since I am going to have the tractor stripped down anyway, now is really the time to break it in half instead of waiting for the inevitable. I bought a new ring gear today ($23.00 from the IH dealer). I will attempt this operation in the next week or so. Is there anything else I should do while I have her in two pieces? Any advice would be appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|