Farmall & IHC Tractors Discussion Board |
IH 140 Gear Box Oil Level and pto seal replacement?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rick S on September 03, 2002 at 11:15:50 from (206.156.86.225):
I have 1965 140IH that I bought about 10 years ago. It has been pretty low maintance. The pto seal has started leaking pretty bad. I stopped by the local dealer and picked up a seal today. I went ahead and picked up seal, gasket and bushing to replace the seal on the belt pulley pto also. Are there any tricks to repalcing these seals? It looks like the rear pto seal will pull out without any disassembly and just hammer the new one back in. The belt pulley seal looks like it will take disassebly to get the seal and bushing in place. Are there any tricks? Also, is there a way to drain and flush the gear box without taking it a part. Would I want to do this or would I just be asking for problems? What is the proper way to fill the gear box to get the correct level of oil in it. I've been filling it until I see the gears throwing a good bit of oil around. I thought there might be a side plug some where that you would remove and fill until oil started coming out of the side plug. Thank you for your advice and help.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|