Farmall & IHC Tractors Discussion Board |
Another H bolster question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Two Bit on August 28, 2002 at 05:44:07 from (168.37.200.246):
Although my H steers OK and there is not too much play in the steering wheel when turning, I noticed that when I jacked up the front of the tractor to pack the front wheel bearings the entire inside shaft has VERTICAL play of at least 1/2" maybe more. I took the top cover off the bolster and the big nut on the top is snug. There was old grease/oil in it so I cleaned out the top end as much as possible without disassembly and repacked with new grease gun grease. Do I need to worry about the vertical play? And if so, what bearing needs to be replaced? The top of the shaft seems to rub lightly on the underside of the bolster cover. This is the entire shaft and axle assembly on a narrow front that I am talking about. Thanks for the help.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|