Farmall & IHC Tractors Discussion Board |
Flaw with unfreezing stuck engine with hydraulics (Part II)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan Kelley on April 23, 2002 at 14:38:13 from (63.104.174.146):
Here's a thought. Instead of hooking up a hydraulic hose to the spark-plug hole, what if I hooked up a grease fitting? Spark plugs are threaded with NPT threads, are they not? Just get a short piece of iron pipe and a pipe cap. Drill a hole in the pipe cap and thread it for the grease fitting. Put the cap on the pipe, the grease fitting in the cap and the pipe in the spark plug hole. I could use my grease gun to force the piston out slowly. This way, I could take out the crank, and do a cylinder at a time. I should not end up with bent rods or flying pistons. The piston/rod may pop a bit coming out, but grease is not very compressible. I could then scrape out the grease, stuff most of it back into my grease gun and do the next cylinder. It might be a bit messy, but who in the tractor world doesn't like a little bit of a mess from time to time? Am I missing something?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|