Farmall & IHC Tractors Discussion Board |
Re: three point conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave_Id on February 17, 2002 at 15:00:18 from (63.15.161.240):
In Reply to: three point conversion posted by mark on February 17, 2002 at 14:49:16:
If your 3 point has it's own cylinder, you should have no problem lifting the box scraper. If it's operated off the rocker shaft, it won't work, unless you rig up a snatch block pulley. As far as using a 3pt log splitter, the drawback is the volumn of the touch control unit. (like 3 qts) You may have to rig up an auxillary tank. I run a splitter on my MF 253 with 12 gallons of hydraulic oil, and after a couple hours of splitting, the valve is too hot to touch.
Follow Ups:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|