Farmall & IHC Tractors Discussion Board |
Re: Super A 12v conversion
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on May 27, 2007 at 10:11:29 from (4.90.52.236):
In Reply to: Super A 12v conversion posted by 51Farmall on May 26, 2007 at 17:26:29:
Heres some mounting plates. http://www.alternatorparts.com/Alternator_brackets_1.htm For the top support I ordered part #60714DA and part #49288DA from OEM Tractor Parts. By useing the two parts together it curves over the alt and with the two slots together you can adjust the tightness. Use this diagram for the three wire conversion. It says for an H/M but it is the same as on a SA. http://albums.photo.epson.com/j/ViewPhoto?u=4001561&a=30065733&p=60243702 Go with the three wire because its hard to get a one wire setup to excite without a small pulley and reving the motor up every time. If you use the delco 10SI it should bolt to your old base with a longer bolt.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|