Farmall & IHC Tractors Discussion Board |
Thanks El Toro, C is running
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Karl Hamson on May 20, 2007 at 12:11:37 from (139.142.96.209):
If all else fails follow instructions. Cleaned and gapped the points as you told me. I spent a frustrating hour crawling under with a flashlight looking for timing marks crawling out again, nudge the crank, back under. Put thumb in plug hole and start all over again. Finally I stuck a piece of bent fence wire down the plug hole and found TDC that way. Still could not see any marks on the flywheel. I reset the rotor timing and the old girl fired on the first flip. I have had this tractor for 12 years and never had to do anything to it before. Now I understand it a little better.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|