Farmall & IHC Tractors Discussion Board |
Electrolysis Success
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by GeneMO on April 20, 2007 at 05:46:56 from (216.74.196.145):
Got"r done!!! It worked. I had narrowed my lack of success down to two problems (I thought) Not enough surface area on the electrode/sacrifical metal side (8 1/2 inch re-bars hanging down in the solution) and I had mixed my water/washing soda too strong (4 55oz boxes in approx 50 gallon of water). So I found some sheet metal and was going to add this to my sacrifical metal side. Then I re read so of the tips I got on this site and realized I had my battery charger leads hooked up backwards!!! I went down and put the negative lead on the part to be cleaned, went to work and by evening the paint/rust/gunk was falling of my Super H gas tank support bracket! I am pleased with the process. I still believe the solution is too strong. It will only operate on 6 volts at about 7 amps. I still trips on 12 v. Gene
Replies:
Home
| Forums
Today's Featured Article -
A Towny Goes Plowing - by Anthony West (UK). I live in an area renowned for its rural beauty. Small fields with hedgerows and trees are common place, as are small hamlets with village greens and the odd duck pond complete with swans. The center of any village once the shop is closed is the old tavern. Rustic places with cheerful names like "The Griffin" "Red Lion" or "The Plough and Harrow" are found dotted around the country lanes all over the place. The warm glow of yellowish light can be seen for quite some distance at dusk, and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|