Farmall & IHC Tractors Discussion Board |
Different crank seal question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Roger Mills on March 26, 2007 at 15:30:23 from (64.122.113.206):
I saw the post on the H front crank seal and I am about to do one on an A. I already know how tough it can be to get the pulley off and think I can handle that part OK. The seal and how to put it in is the question. The front cover plate appears to have a lip around the outside of where the seal goes. So-do you just wiggle it in around the crankshaft?? Any tips or suggestions on the easiest way to do it without harming the seal would be greatly appreciated. By the way, I noticed that the lip is very slightly crooked, round but at a slight angle compared to the back step on the pulley-I don't think it should be that way and wonder if anyone has dealt with that. This thing doesn't just seep oil, it slings it-1/2 cup in about an hour. I think the crooked lip has the seal at an angle and its not sealing at all. I just hope I don't have to pull the front cover.
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|