Farmall & IHC Tractors Discussion Board |
Re: REMOVING GREASE AND GASKETS
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on March 12, 2007 at 18:16:37 from (66.173.50.149):
In Reply to: REMOVING GREASE AND GASKETS posted by RICK IN VERMONT on March 12, 2007 at 16:27:14:
Rick, There is no reliable way to repair a gasket from the "outside" Some gaskets are leaking from under tightened bolts, but usually from Thermal cycling and old age. We do not know what you are working on, but since you are on the IH forum, I assume the dealer will have the gaskets. This site also sells new gaskets. Do not over tighten bolts, that is worse when they break, or crack and warp the tin pieces. A manual is a a must. Also available here. or Binders Books. Pressure washers are fine tools if used with discression around electrical components. (best to remove them ahead of washing) Renting them is easy and modest in cost. Good luck, JimN
Replies:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|