Farmall & IHC Tractors Discussion Board |
Draw bar for a 560
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Curt on January 05, 2002 at 19:38:45 from (12.253.102.126):
For the last two years I have been using my 1959 560D with a fast hitch mounted draw bar to pull a JD 14T baler. We just bought a newer JD 467 baler that has an equal angle hitch that requires a straight draw bar about 8" long to go into a receiver on the hitch of the baler. I was going to modify the fast hitch draw bar with a longer hitch plate, but the baler has a requirement that the hole in draw bar must be 14" from the tip of the PTO shaft. This requirement is impossible to meet using the fast hitch draw bar. Is there a standard draw bar that can be mounted on a 560? What did a non-fast hitch 560 use?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|