Farmall & IHC Tractors Discussion Board |
Need Hydraulic motor info
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Moose on November 21, 2001 at 20:56:49 from (12.78.117.133):
If memory serves me correctly, I recall someone in this group had a pretty good knowledge of hydraulics. I have aquired an old Tulsa Winch that I would like to mount on a 3-point frame. This is a large capacity 20,000 lb worm-gear winch capable of holding over 200 ft. of 1/2 in. cable. It was used on a heavy tow truck and sprocket drive off what I assume was a truck pto. It currently has a #60 chain sprocket (30 teeth) welded on the input shaft. The winch is 30 to 1 ratio. For the installation I am contemplating, a hydraulic drive motor would be preferred over running a pto shaft. However, I know nothing about hydraulic motors. My tractor has a 19 gpm output at the rear ports. What size motor would turn this winch and should it be geared down from the 30 tooth sprocket now on the winch or should it be direct-drive to the input shaft? What would keep the winch from back-lashing the hydraulic motor under tension? I would be using the winch for log skidding, boulder removal and other heavy work.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|